Caprice Wagon V8-350 5.7L (1994)
Removing And Installing Shaft Seal And O-Ring
1. Dip the new seal seat O-ring in clean 525 viscosity refrigerant oil and assemble onto O-ring installer J 33011.
2. Insert the O-ring installer J 33011 into the compressor neck until the installer "bottoms". Lower the moveable slide of the O-ring installer to
release the O-ring into the seal O-ring lower groove. (The compressor neck top groove is for the shaft seal retainer ring.) Rotate the installer to seat
the O-ring and remove the installer.
3. Dip the new seal in clean 525 viscosity refrigerant oil and assemble seal to Seal Installer J 23128-A by turning handle clockwise. The stamped
steel case side of the lip seal must be engaged with knurled tangs of installer so that flared-out side of lip seal is facing and installed towards the
compressor. Install seal protector J 34614 in the seal lip and place over the compressor shaft and push the seal in place with a rotary motion or
