Caprice Wagon V8-350 5.7L (1994)
Removing Knock Sensor Module From PCM
7. Remove knock sensor module from PCM
Install or Connect:
1. Install knock sensor module and access cover
2. Install PCM in vehicle
3. Connect PCM electrical connectors
4. Connect PCM mounting hardware
5. Connect negative battery cable
EEPROM Programming
CAUTION:The software/calibration used for PCM reprogramming must match the vehicle application, or improper operation and/or damage may
occur.
^
Ensure battery is charged
^
Turn ignition "ON"
^
Ensure connections to the Data Link Connector (DLC) and battery/cigar lighter are secure
^
Follow the most current Techline terminal/equipment instructions
PCM Reprogramming Failure
^
Check PCM connections
^
Check Decline terminal/equipment for latest software version
^
Repeat reprogramming procedures. If it fails again, replace the PCM. The replacement PCM must be programmed.
PCM Functional Check
^
Refer to DIAGNOSIS, TESTING AND INSPECTION PROCEDURES.
