chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Tools - SIR Driver/Passenger Load Tool and Adapter|Page 7003 > < Tools - SIR Driver/Passenger Load Tool and Adapter|Page 7001
Page 8
background image

CAUTION:

Safety precautions must be observed when handling a deployed inflator module. After deployment, the metal surfaces of the inflator module will be
hot. Allow the inflator module to cool before handling any metal portion of it. Do not place the deployed inflator module near any flammable objects.
Failure to follow procedures may result in fire or personal injury. After an inflator module has been deployed, the metal canister and surrounding
areas of the inflator module will be hot. Do not touch the metal areas of the inflator module for about ten minutes after deployment. If the deployed
inflator module must be moved before it is cool, wear gloves and handle by the air bag itself. Refer to Figure 8.

22.

Disconnect the pigtail adapter from the inflator module as soon after deployment as possible to avoid damage to the pigtail adapter or SIR
Deployment Harness from contacting the hot inflator module canister. The pigtail adapter and SIR Deployment Harness are designed to be reused.
They should, however, be inspected for damage after each deployment and replaced if necessary.

23.

Dispose of the deployed inflator module through normal refuse channels after it has cooled for at least 10 minutes.

24.

Wash your hands with mild soap and water afterward.

NOTICE:

The remaining steps are to be followed in the unlikely event that the inflator module did not deploy after following the above procedures.

25.

Ensure that the SIR Deployment Harness has been disconnected from the power source and that its two banana plugs have been shorted together
by fully seating one banana plug into the other. Refer to Figure 1.

26.

Disconnect the pigtail adapter from the inflator module.

CAUTION:

When storing a live inflator module or when leaving a live inflator module unattended on a bench or other surface, always face the bag up and away
from the surface. This is necessary so that a free space is provided to allow the air bag to expand in the unlikely event of accidental deployment.
Failure to follow procedures may result in personal injury.

Tools - SIR Driver/Passenger Load Tool and Adapter|Page 7003 > < Tools - SIR Driver/Passenger Load Tool and Adapter|Page 7001