Caprice Wagon V8-350 5.7L (1994)
Band Apply Servo: Service and Repair
Fig.17 Servo Cover Removal
REPLACE
1. Disconnect battery ground cable.
2. Remove exhaust system as described under TCC Solenoid & Wiring Harness. Refer to Torque Converter Clutch Solenoid. See: Actuators and
Solenoids - A/T/Torque Converter Clutch Solenoid/Service and Repair
3. Remove transmission oil pan bolt below servo cover, Fig. 17.
4. Install servo cover depressor tool No. J-29714-A or equivalent on oil pan and install bolt included with tool, Fig. 17.
5. Depress servo cover and remove retaining ring.
6. Remove tool from oil pan.
7. Remove cover and seal ring.
8. Remove servo piston and bore apply pin assembly.
9. Reverse procedure to install.
