Cavalier L4-144 2.4L DOHC VIN T SFI (1997)
REMOVE OR DISCONNECT
1. Connector from wheel speed sensor.
2. Harness attaching clips for control arm and splash shield.
3. Lower vehicle.
4. Harness attaching clips from strut tower.
5. Cut wheel speed sensor wiring circuits within main engine harness.
6. Strip insulation on engine harness leads and new wheel speed sensor harness leads.
INSTALL OR CONNECT
1. Splice sleeve provided in jumper harness kit over each engine harness leads.
2. New wheel speed sensor harness leads to engine harness leads (matching color) and crimp connections.
3. Heat shrink tube lightly to seal.
4. Harness attaching clip to strut tower.
5. Raise and support vehicle on suitable hoist.
6. Harness attaching clips to control arm and splash shield.
7. Connector to wheel speed sensor.
