Cavalier L4-144 2.4L DOHC VIN T SFI (1997)
INSTALL OR CONNECT
1. Master cylinder and modulator assembly to power booster assembly. Tighten master cylinder and modulator assembly mounting nuts to 27 Nm (20
ft. lbs.).
2. Brake pipes tube nuts to master cylinder and modulator assembly. Tighten brake pipe tube nuts to 23 Nm (17 ft. lbs.).
3. Electrical connector to fluid level switch.
4. Electrical connectors from both solenoids.
5. 3-pin and 6-pin motor pack electrical connectors.
6. Fill master cylinder to proper level with clean brake fluid.
7. Bleed hydraulic system. See: Service and Repair
8. Battery.
9. Air box.
Reservoir Cap Service
REMOVE OR DISCONNECT
1. Thoroughly clean the master cylinder reservoir cap before removal to avoid dirt entering the reservoir.
2. Reservoir cap.
3. Rubber diaphragm from cap. Clean any brake fluid that exits between cap and rubber diaphragm with a dry lint free rag. Inspect brake fluid for
proper level. Remove fluid if necessary.
INSTALL OR CONNECT
1. Diaphragm into cap.
2. Cap to reservoir.
