Cavalier L4-2.2L VIN 4 (1998)
11. Remove the bleeder valve and bleeder valve (5) cap from the caliper.
12. Clean all parts in clean, denatured alcohol.
13. Dry the parts with unlubricated compressed air.
14. Blow out all passages in the caliper housing and bleeder valve.
INSTALLATION PROCEDURE
Tools Required
^
J29077-A Front Disc Brake Caliper Dust Boot Installer
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
1. Assemble the bleeder valve (5) and bleeder valve cap into caliper.
^
Tighten the bleeder valve to 13 Nm (115 inch lbs.).
2. Lubricate the new piston seal (2) and install the new piston seal into the caliper bore groove.
3. Make sure the seal (2) is not twisted.
