Cavalier L4-2.2L VIN 4 (1998)
1. Place a 2-mm diameter bead of GM P/N 12346286 Loctite 5900 or equivalent to the oil pan sealing surface, except at the rear seal mounting
surface.
2. Using a new oil pan rear seal, apply a thin coat of GM P/N 12346286 Loctite 5900 or equivalent on the ends down to the ears.
3. Install the oil pan.
NOTICE: Refer to Fastener Notice in Service Precautions.
4. Install the oil pan bolts.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
5. Install the oil pan nuts.
^
Tighten the nuts to 10 Nm (89 inch lbs.).
6. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement
7. Install the starter. Refer to Starter Motor Replacement in Engine Electrical.
8. Install the transmission converter cover or flywheel housing cover.
9. Install the right engine splash shield.
10. Install the right front tire and wheel assembly.
11. Lower the vehicle.
12. Fill the crankcase with engine oil.
13. Connect the negative battery cable.
