Cavalier L4-2.2L VIN 4 (1998)
1. Install the new oil filter neck seal. Tap gently and evenly on the seal in order to prevent damage to the case bore or the seal.
2. Install the new oil filter.
3. Install the oil pan gasket and the oil pan. Use a new gasket if the sealing rings are damaged.
4. Install the oil pan attaching bolts.
^
Tighten the bolts to 14 Nm (124 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Lower the vehicle.
6. Fill the transmission to the proper level with DEXRON(R) III oil.
7. Inspect the oil pan gasket for leaks.
A/T Fluid/Filter Changing
REMOVAL PROCEDURE
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Place a drain pan under the transmission oil pan.
3. Remove the oil pan bolts from the front and the sides only.
4. Loosen the rear oil pan bolts approximately 4 turns.
NOTICE: Pry the oil pan down carefully in order to prevent damage to the transmission case or the oil pan sealing surfaces.
