Cavalier L4-2.2L VIN 4 (1998)
Tighten
Tighten the clamp to 5 Nm (44 lb in).
50.
Connect the electrical connector to the sensor in the air cleaner outlet duct.
51.
Install the two 10 mm hex head bolts that secure the air cleaner outlet resonator.
Tighten
Tighten the bolts to 10 Nm (89 lb in).
52.
Reinstall the negative battery cable to the battery.
Tighten
Tighten the bolt to 16 Nm (12 lb ft).
Important:
Do not use a remote starter device in the next step. The vehicle ignition switch must be used to start the vehicle (turn ignition switch to crank
position) to verify that the ignition switch is in good working condition.
53.
Using the ignition key, start the engine and allow it to run approximately 5 seconds. After 5 seconds, turn the engine off for approximately 5
seconds. Repeat this 6 times.
^
If the starter cranks the engine 6 times in a row, proceed to the next step.
^
If the starter will NOT crank the engine, skip to Procedure A for Achieva/Grand Am/Skylark
54.
Check the engine oil level and add as necessary.
1998 N Car - Achieva/Grand AM/Skylark - Procedure A(All Engine)
1998 N Car - Achieva/Grand Am/Skylark - PROCEDURE A (all engines)
1.
Remove the fuse panel trim plate from the Instrument Panel (I/P) and remove the 15 amp AIR BAG fuse.
2.
Remove the left side dash lower insulation panel.
3.
Remove the Connector Position Assurance (CPA) from the yellow air bag connector located at the base of the steering column and disconnect the
connector.
4.
Remove the left side knee bolster trim panel.
5.
If equipped, remove the tilt steering column lever.
6.
Remove the bezel around the key lock cylinder.
7.
Remove the screws that hold the steering column trim in place.
8.
Remove both halves of the steering column trim.
9.
Disconnect the wiring from the ignition switch.
