Cavalier L4-2.2L VIN 4 (1998)
24.
Thoroughly clean the interface surfaces of the "S" terminal. Be sure the "S" terminal is snug to the starter solenoid cap.
25.
Install the small ring terminal on the red wire of the service harness kit and install it on the "S" terminal. Reinstall the nut.
Tighten
Tighten the nut to 2.5 Nm (22 lb in).
Important:
In the next step, make sure the battery cable is the last cable positioned on the starter solenoid "B" terminal so that the nut is tightened against
the battery cable.
26.
Thoroughly clean the interface surfaces of the "B" terminal on the starter solenoid.
27.
Clean the fusible link terminal on the vehicle wiring harness and install it on the starter solenoid "B" terminal.
28.
Install the large ring terminal on the harness kit on the starter solenoid "B" terminal.
29.
Clean and install the positive battery cable on the starter solenoid "B" terminal. Install the nut.
Tighten
Tighten the nut to 11 Nm (97 lb in).
30.
On 1998 models, remove one of the bolts (2) that attach the starter solenoid to the starter motor. On 1999-2001 models, remove one of the long
bolts (1) that hold the starter motor end cap to the housing.
31.
On 1998 models, install the ground ring terminal (black wire) on the harness kit on the bolt and reinstall the bolt in the starter solenoid. On
1999-2001 models, install the ground ring terminal (black wire) on the long bolt and reinstall the bolt in the starter.
Tighten
Tighten the starter solenoid bolt or long starter motor bolt to 9 Nm (80 lb in).
32.
Reinstall the negative battery cable to the battery.
Tighten
