Cavalier L4-2.2L VIN 4 (1998)
In the next step, make sure the battery cable is the last cable positioned on the starter solenoid "B" terminal so that the nut is tightened against
the battery cable.
24.
Thoroughly clean the interface surfaces of the "B" terminal on the starter solenoid.
25.
Clean the fusible link terminal on the vehicle wiring harness and install it on the starter solenoid "B" terminal.
26.
Install the large ring terminal on the harness kit on the starter solenoid "B" terminal.
27.
Clean and install the positive battery cable on the starter solenoid "B" terminal. Install the nut.
Tighten
Tighten the nut to 11 Nm (97 lb in).
28.
Lower the vehicle.
29.
Reinstall the negative battery cable to the battery.
Tighten
Tighten the bolt to 16 Nm (12 lb ft).
Important
Do not use a remote starter device in the next step. The vehicle ignition switch must be used to start the vehicle (turn ignition switch to crank
position) to verify that the ignition switch is in good working condition.
30.
Using the ignition key, start the engine and allow it to run approximately 5 seconds. After 5 seconds, turn the engine off for approximately 5
seconds. Repeat this 6 times.
^
If the starter cranks the engine 6 times in a row, no further action is required.
^
If the starter will NOT crank the engine, skip to Procedure A for N Car Achieva/Grand Am/Skylark.
1998 N Car - Achieva/Grand AM/Skylark with 2.4L(VIN Code T)
1998 N Car - Achieva/Grand Am/Skylark with 2.4L Engine (VIN Code T)
1.
Remove the two 10 mm hex head bolts that secure the air cleaner outlet resonator to the throttle body.
2.
Disconnect the electrical connector from the sensor in the air cleaner outlet duct.
3.
Loosen the clamp that secures the air cleaner outlet duct to the air cleaner housing.
4.
Loosen the clamp that secures the air cleaner outlet resonator to the throttle body.
5.
Remove the air cleaner outlet duct and the air cleaner outlet resonator from the throttle body.
