Cavalier L4-2.2L VIN 4 (1998)
50.
Install the air cleaner outlet resonator on the throttle body.
Tighten
Tighten the clamp to 5 Nm (44 lb in).
51.
Connect the air cleaner outlet duct to the air cleaner housing.
Tighten
Tighten the clamp to 5 Nm (44 lb in).
52.
Connect the electrical connector to the sensor in the air cleaner outlet duct.
53.
Install the two 10 mm hex head bolts that secure the air cleaner outlet resonator.
Tighten
Tighten the bolts to 10 Nm (89 lb in).
54.
Reinstall the negative battery cable to the battery.
Tighten
Tighten the bolt to 16 Nm (12 lb ft).
Important
Do not use a remote starter device in the next step. The vehicle ignition switch must he used to start the vehicle (turn ignition switch to crank
position) to verify that the ignition switch is in good working condition.
55.
Using the ignition key, start the engine and allow it to run approximately 5 seconds. After 5 seconds, turn the engine off for approximately 5
seconds. Repeat this 6 times.
^
If the starter cranks the engine 6 times in a row, proceed to the next step.
^
If the starter will NOT crank the engine, skip to Procedure A for J Car Cavalier/Sunfire.
56.
Check the engine oil level and add as necessary.
1999-2001 J-Car - Cavalier/Sunfire with 2.4L Engine (VIN Code T)
1.
Remove the two 10 mm hex head bolts that secure the air cleaner outlet resonator to the throttle body.
2.
Disconnect the electrical connector from the sensor in the air cleaner outlet duct.
3.
Loosen the clamp that secures the air cleaner outlet duct to the air cleaner housing.
4.
Loosen the clamp that secures the air cleaner outlet resonator to the throttle body.
5.
Remove the air cleaner outlet duct and the air cleaner outlet resonator from the throttle body.
