chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

ABOUT US
Manifold Absolute Pressure (MAP) Sensor <--> [Manifold Pressure/Vacuum Sensor] > < Diagram Information and Instructions|Page 971

Cavalier L4-2.2L VIN 4 (1998)

Page 1
background image

Knock Sensor: Service and Repair

Knock Sensor Wiring Harness Connector

Knock Sensor

REMOVAL PROCEDURE

1. Disconnect the negative battery cable.
2. Raise the vehicle. Suitably support the vehicle.
3. Remove the Knock Sensor wiring harness connector from the knock sensor.
4. Remove the knock sensor from the engine block.

INSTALLATION PROCEDURE

1. After cleaning the threads thoroughly, install the knock sensor into the engine block. Tighten the knock sensor to 16-22 Nm (12-16 lb ft).
2. Install the KS wiring harness connector to the knock sensor.
3. Lower the vehicle.
4. Connect the negative battery cable.

Manifold Absolute Pressure (MAP) Sensor <--> [Manifold Pressure/Vacuum Sensor] > < Diagram Information and Instructions|Page 971