Cavalier L4-2.2L VIN 4 (1998)
10.
Remove the two screws (2) holding the ignition switch (3) to the steering column (1). Remove the ignition switch from the steering column.
Notice
The ignition switch mounting screws and the screws that secure the upper and lower halves of the steering column covers are self-tapping. To
prevent stripping the screws when attaching the ignition switch and steering column covers, the following procedure should be used:
^
Place the screw into position and with slight pressure, rotate the screw in a counterclockwise (loosening) direction.
^
When the original thread is located, the screw will drop slightly; reverse direction and tighten the screw.
11.
Position the new ignition switch to the column and check for proper location of the tab. Install both screws.
Tighten
Tighten both screws to 1.4 Nm (12 lb in).
12.
Attach the wiring harness connectors to the ignition switch.
13.
Reinstall the upper and lower steering column covers.
Tighten
Tighten the fasteners to 9 Nm (80 lb in).
14.
Reinstall the knee bolster trim.
Tighten
Tighten the fasteners to 2 Nm (18 lb in).
15.
Reconnect the yellow airbag connector at the base of the steering column and install the CPA.
16.
Reinstall the sound insulator panel.
Tighten
Tighten the fasteners to 2 Nm (18 lb in).
17.
Reinstall the 15-amp AIR BAG fuse into the fuse box and replace the I/P trim cover.
18.
Turn the ignition switch to the ON position and verify that the AIR BAG indicator light flashes seven times and goes out.
1998 - 2001 J-Car - Cavalier/Sunfire With 2.4L (VIN Code T)
1998 J-Car - Cavalier/Sunfire with 2.4L Engine VIN Code T)
1.
Remove the two 10 mm hex head bolts that secure the air cleaner outlet resonator to the throttle body.
2.
Disconnect the electrical connector from the sensor in the air cleaner outlet duct.
