Cavalier L4-2.2L VIN 4 (1998)
Wheels: Service and Repair
Aluminum Wheel Hub Cap Replacement
REMOVAL PROCEDURE
1. Raise and suitably support the vehicle.
2. Remove the tire and the wheel assembly. Refer to WHEEL REMOVAL.
3. Use the following procedure in order to remove the hub cap:
^
Place a block of wood, approximately 50 mm (2 in) in diameter with a squared off end, against the back surface of the cap.
^
Strike the block of wood sharply with a hammer in order to remove the cap.
INSTALLATION PROCEDURE
1. Install the hub cap using the following procedure:
^
Place the cap into position at the wheel opening.
^
Place a block of wood, at least 75 mm t3 in), on the diameter against the cap face.
NOTICE: Failure to hit the cap squarely without the load distributed evenly could result in permanent damage to the cap.
^
Install the cap by striking the block of wood with a harmer.
2. Install the tire and the wheel assembly. Refer to WHEEL INSTALLATION.
