Cavalier L4-2.2L VIN 4 (1998)
Fluid Line/Hose: Technical Service Bulletins
Transaxle Cooler Line - Seal Installation Procedure
File In Section: 7 - Transmission
Bulletin No.: 87-71-67
Date: June, 1998
INFORMATION
Subject:
Transaxle Cooler Line Seal Installation Procedure
Models:
1995-98 Chevrolet Cavalier
1997-98 Chevrolet Malibu
1997-98 Oldsmobile Cutlass
1999 Oldsmobile Alero
1995-98 Pontiac Sunfire
1999 Pontiac Grand Am
with HYDRA-MATIC 4T40-E Transaxle (RPO MN4) or 4T45-E Transaxle
RPO MN5) and 2.2L, 2.4L, 3.1 L, 3.4L Engine
VINs 4, T, M, E - RPOs LN2, LD91 L821 LA1)
This bulletin contains information regarding the installation of cooler line seals into the case of either a 4T40-E or 4T45-E transaxle.
Seal Installation Procedure (Figure 1)
To prevent automatic transmission fluid from leaking from the cooler line seals (49) after installing new seals, perform the following procedure.
Important:
Only GM Goodwrench DEXRON(R) III automatic transmission fluid should be used as part of warranty repair of GM Powertrain automatic
transmissions.
Notice:
Failure to lubricate the cooler line seals (49) with automatic transmission fluid DEXRON(R) III, before installing the cooler line pipes into the seals,