Cavalier L4-2.2L VIN 4 (1998)
^
Tools Required
-
J 41228 Stub Shaft Sleeve Installer
1. Install a new sleeve on the stub shaft. Use the J 41228. Install the J 41228 so that the collar is in the snap ring groove.
2. Install the two new snap rings on the stub shaft.
3. Add Polyurea grease to the splines of the output shaft in order to prevent damage to the shaft splines during vehicle operation.
4. Install the stub shaft into the transmission assembly.
5. Install the drive axle assembly. Refer to Wheel Drive Shafts Replacement in Wheel Drive Shafts.
6. Lower the vehicle.
7. Inspect the shaft sleeve for leaks.
8. Verify the oil level.
