Cavalier L4-2.2L VIN 4 (1998)
7. Place the halfshaft assembly onto the arbor press.
^
The tripot spider assembly must be on the press plate.
^
The CV joint assembly must be under the press head.
8. Lower the arbor press head onto the CV joint assembly until the tripot spider is next to the spacer ring. Do not exceed 4,000 lbs. press load during
assembly.
9. Remove the halfshaft assembly from the arbor press.
10. Place the new spacer ring (2) on the halfshaft bar groove at the end of the halfshaft bar.
11. Slide the tripot boot (7) the corresponding groove on the halfshaft bar.
12. Crimp the small boot retaining clamp (6) using J 35910.
13. Place approximately a 1/4 of the grease from the service kit in boot. Use the remainder to repack the housing.