Cavalier L4-2.2L VIN F (2004)
Antenna Cable: Service and Repair
Coaxial Cable Replacement - Digital Radio
COAXIAL CABLE REPLACEMENT - DIGITAL RADIO
REMOVAL PROCEDURE
1. Remove the rear window trim panel.
2. Disconnect the coaxial cable connector (4) from the digital radio receiver.
3. Cut off the visible end from the coaxial cable.
4. Lower the headliner enough to access the wire harness.
5. Disconnect the coaxial cable connectors (3) at the antenna base.
6. Cut off the visible end of the coaxial cable.
INSTALLATION PROCEDURE
1. Position the replacement coaxial cable (4) along side the old coaxial cable harness. Secure the new coaxial cable to the old coaxial harness every
150 mm (6 in) with electrical tape, nylon straps, or a hot glue gun.
2. Connect the coaxial cable to the pigtail connector (2) at the antenna base.
3. Install the headliner (8) to the original position.
4. Install the coax cable connector (5) to the digital radio receiver.
5. Install the rear window trim panel.
