Cavalier L4-2.2L VIN F (2004)
2.
Connect the Techline Information System (TIS) terminal to the Tech2(R).
3.
Scroll to the bottom of the Controller List, and select the "ONSA TIS2WEB Pass-Thru OnStar(R) Activation (Replaced/Upgraded Units
Only)" option using the Service Programming System (SPS).
Important:
Do not use the clear DTC function. This will only temporarily turn the LED to green.
4.
Upon completion of the OnStar(R) TIS2WEB step, disconnect the TIS terminal from the Tech2(R) and perform the VCIM/OnStar(R)
Set-up Procedure using the Tech2(R). The set up procedure is located under the special function menu option.
Important:
Failure to perform the above steps will result in a red LED, DTC being set and limited or incomplete OnStar(R) services, and will
require a customer return visit to the dealership.
5.
The default language for the new VCIM will be English. To change to French or Spanish, access the special functions menu on the Tech
2(R), and follow the instructions accordingly.
7.
Skip to the next step if the vehicle to be upgraded is not listed below:
^
2002-2004 Cadillac DeVille
^
2002-2004 Cadillac Seville
^
2005 Cadillac STS
Set up the Dash Integration Module (DIM) using the following procedure:
1.
On the Tech2(R) select the correct Year, Make and Model.
2.
Enter Dash Integration Module (DIM) > Special Functions > Set Options > Misc. Options 1 > and turn off phone (if the vehicle does not
have the UV8 option).
3.
Enter Nav Radio Present and set to "No Nav" (if the vehicle does not have a navigation radio).
4.
Turn the ignition off and open the door to turn off the RAP.
5.
Turn the ignition on and enter the Vehicle Comm. Interface Module > Special Functions > Set Up OnStar /VCIM.
6.
When prompted select "No Phone" (if the vehicle does not have the UV8 phone) and "No Nav" (if the vehicle does not have a navigation
radio).
7.
Turn the ignition off and open the door to turn off the RAP.
Important:
OnStar(R) Emergency Services are immediately available after these steps, however, full configuration, including activation of
Hands-Free Calling, may take up to 24 hours to complete.
Processing the Module Exchange
Processing the Module Exchange
For this program, submitting a credit request for the removed OnStar(R) VCIM (the core) will be performed through a website. When this process is
followed, the removed Analog / Digital-Ready VCIM, in most cases, will not be mailed back to the distributor, but can be scrapped by the dealership.
U.S. Dealers
1.
Return the removed Analog / Digital-Ready OnStar(R) VCIM to the Parts Manager.
2.
The Parts Manager will log onto www.autocraft.com.
3.
Select Account Maintenance.
4.
Select Outstanding Cores.
