Cavalier L4-2.2L VIN F (2004)
Notice: Refer to Exterior Trim Emblem Removal Notice in Service Precautions.
4. Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.
5. When replacing, remove all adhesive as follows:
*
For body panels, use a 3M(TM) Scotch Brite molding adhesive remover disk 3M(TM) P/N 07501 or equivalent.
*
For plastic panels, use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a, 50/50 mixture, by volume of isopropyl alcohol
and water to remove the adhesive.
Installation Procedure
Important: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the
sticky backing. Foreign material may cause improper adhesion.
1. Clean the area where the emblem/nameplate will be installed.
Use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a, 50/50 mixture, by volume of isopropyl alcohol and water to clean the
area.
2. Dry the area thoroughly.
3. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions:
4. For the SUNFIRE emblem/nameplate, install to the following dimensions:
*
Dimension (a) is 57 mm (2.250 in) from the front edge of the door to the front of the emblem/nameplate.
*
Dimension (b) is 39 mm (1.500 in) from the top of the door molding to the bottom of the emblem/nameplate.
5. For the SUNFIRE GT emblem/nameplate, install to the following dimensions:
