chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Center Pillar Upper Trim Panel Replacement|Page 7575 > < Center Pillar Upper Trim Panel Replacement|Page 7573
Page 2
background image

6. Remove the push-in retainers (2) near the tail lamps, if equipped.
7. Fold down the rear seat back.
8. Remove the push-in retainer from the left rear shock tower.

9. Fold the right section of the rear compartment trim panel toward the center of the compartment and remove it.

Installation Procedure

1. Install the trim panel into the rear compartment.
2. Adjust the trim panel to the desired appearance.
3. Align the trim panel with the slots in the rear body panel, and press until the plate clips are fully engaged.
4. Install the rear compartment spare tire cover.

Notice:  Refer to Fastener Notice in Service Precautions.

5. Install the spare tire cover retainer.

Tighten the retainer to 1.5 N.m (13 lb in).

Center Pillar Upper Trim Panel Replacement|Page 7575 > < Center Pillar Upper Trim Panel Replacement|Page 7573