Cavalier L4-2.2L VIN F (2004)
5. Install the caliper assembly to the steering knuckle.
Notice: Refer to Fastener Notice in Service Precautions.
6. Tighten the caliper bolts to the steering knuckle.
^
Tighten the bolts to 51 Nm (38 ft. lbs.).
7. Remove the caps or plugs from the opening in the brake caliper and the brake hose.
Important: Install NEW copper brake hose gaskets (2).
8. Assemble the NEW copper brake hose gaskets (2), and the brake hose bolt (1), to the brake hose (3).
Notice: Refer to Fastener Notice in Service Precautions.
9. Install the brake hose-to-brake caliper bolt to the brake caliper.
^
Tighten the bolt to 50 Nm (37 ft. lbs.).
10. Bleed the hydraulic brake system.
11. Remove the wheel nuts securing the rotor to the hub.
12. Install the tire and wheel assembly.
13. Lower the vehicle.
14. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
15. Slowly release the brake pedal.
16. Wait 15 seconds, then gradually apply the brake pedal approximately 2/3 of its travel distance again until a firm brake pedal apply is obtained.
This will properly seat the brake caliper pistons and brake pads.
