Cavalier L4-2.2L VIN F (2004)
4. Install the master cylinder mounting nuts (2).
^
Tighten the nuts to 27 Nm (20 ft. lbs.).
5. Remove the caps from brake pipes (4).
6. Connect the brake pipe fittings (4) at the master cylinder (1).
^
Tighten the fittings to 23 Nm (17 ft. lbs.).
7. Connect the electrical connector (3) to the brake fluid level sensor.
8. Bleed the hydraulic brake system.
Master Cylinder Reservoir Replacement
Master Cylinder Reservoir Replacement
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
1. Remove the master cylinder from the vehicle.
2. Secure the master cylinder in a vise. Do not clamp the master cylinder body' secure only at the flange.
3. Using needle nose pliers, carefully depress the retaining tabs on the end of the brake fluid level sensor (1), and press the sensor through the
reservoir (2) to remove.
4. Carefully tap out the reservoir retaining pins.
5. Remove the reservoir from the from the master cylinder by pulling the reservoir straight up and away from the cylinder.
6. Remove the seals from the master cylinder.
Installation Procedure
