Cavalier L4-2.2L VIN F (2004)
Drive Belt Tensioner: Service and Repair
Drive Belt Tensioner Replacement
^
Tools Required
-
J 45025 Torque Wrench Adapter
Removal Procedure
1. Remove the drive belt.
2. Remove the drive belt tensioner bolt.
3. Remove the drive belt tensioner.
Installation Procedure
1. Install the drive belt tensioner.
Notice: Refer to Fastener Notice in Service Precautions.
Important: In order to obtain the proper torque when using any torque wrench adapter you must use the following formula: Pre-set Torque = Torque
Wrench Length x Torque Desired divided by Torque Wrench Length + Extension Length.
2. Install the drive belt tensioner bolt.
^
Use a J 45025 Torque Wrench Adapter to tighten the drive belt tensioner bolt.
^
Tighten the drive belt tensioner bolt to 45 Nm (33 ft. lbs.).
3. Install the drive belt.
