Cavalier L4-2.2L VIN F (2004)
1.
Remove the camshaft cover and inspect for heat stake marks in the locations shown. Refer to Camshaft Cover Removal in the appropriate Service
Information (SI) procedures.
Important:
The oil fill tube must be replaced along with the camshaft cover for the following models:
^
2005 Chevrolet Cobalt
^
2005 Pontiac Pursuit
^
2005 Saturn ION
1.
If the heat stake marks are not present, replace the camshaft cover with a new one.
2.
If the heat stake marks are present, re-install the camshaft cover on the engine. Refer to Camshaft Cover Installation in the appropriate Service
Information (SI) procedures.
Intake Manifold
1.
Remove the intake manifold from the cylinder head. Refer to Intake Manifold Removal in the appropriate Service Information (SI) procedures.
2.
Attempt to insert the chuck end of a 2.0 mm (5/64 in) drill bit into the PCV orifice where shown. The orifice is slightly below the surface.
3.
If the chuck end of the drill bit can be inserted, replace the intake manifold with a new one.
4.
If the chuck end of the drill bit cannot be inserted, re-install the intake manifold to the cylinder head. Refer to Intake Manifold Installation in the
appropriate Service Information (SI) procedures.
5.
If the information in this bulletin did not correct the excessive oil consumption condition, refer to Oil Consumption Diagnosis in the appropriate
Service Information (SI) procedures.
