Cavalier L4-2.2L VIN F (2004)
4.
After the wheel covers are completely dry, each wheel cover should be wiped with isopropyl alcohol on a clean, lint-free, non-abrasive cloth at the
insulator locations. Refer to the illustrations above.
Important:
There is no tolerance allowed for gaps between the insulator and the wheel cover lip. It is also ideal to have the insulator flush (1) against the
rib, but there is a tolerance of up to 6 mm (0.236 in) for a gap (2) between the insulator and the rib.
5.
Peel the red non-stick backing off of the insulator.
6.
Carefully place the insulator onto the wheel cover so that the area under the lip is resting against the corner of the inside edge of the wheel cover
lip.
7.
Rotate the insulator until it is flush against the inside edge of the wheel cover lip.
8.
Press down firmly on the insulator to ensure that the adhesive is bonding to the wheel cover.
