Cavalier L4-2.2L VIN F (2004)
5.
Observe the fuel pressure gage with the fuel pump commanded ON.
^
If the fuel pressure IS between 345-414 kPa (50-60 psi), fuel system pressure is not the cause. Refer to the appropriate SI Document for
additional diagnostic information.
^
If the fuel pressure IS LESS THEN 345-414 kPa (50-60 psi), continue with the next step.
6.
Remove the fuel pump module. Refer to Fuel Pump Module Replacement in SI. Use the appropriate SI Document depending on model and year.
7.
Flush the fuel tank with hot water.
8.
Pour the water out of the fuel sender assembly opening in the fuel tank. Rock the fuel tank in order to be sure that the removal of the water from
the fuel tank is complete.
9.
Allow the tank to dry completely before reassembly. Refer to Fuel System Cleaning for additional information.
Caution:
The pot of the sending unit may have fuel in it. Use caution not to spill fuel on yourself while servicing the strainer.
Note:
Use care not to damage the fuel module pot when removing the old strainer. Damage to the pot may make it difficult or impossible to install
the new strainer and/or make the module inoperative.
10.
Insert the tip of a small screw driver between the strainer and the pot and push the screwdriver up slowly while rotating the screwdriver to pop off
the strainer.
