Cavalier L4-2.2L VIN F (2004)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module (EBCM) Replacement
Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to
observe this precaution could result in damage to the EBCM/EBTCM.
Removal Procedure
1. Turn the ignition switch to the OFF position
2. Clean the Electronic Brake Control Module (EBCM) to Brake Pressure Modulator Valve (BPMV) area of any accumulated dirt and foreign
material.
3. Disengage the electrical Connector Position Assurance (CPA) locking tab (1) from the connector sliding cover lock tab.
4. Depress the cover lock tab, then move the sliding connector cover (2) to the open position.
5. Disconnect the electrical harness connector (4) from the EBCM (3).