Cavalier L4-2.2L VIN F (2004)
12.
Lower the vehicle.
13.
Using the Tech 2(R) Diagnostic Scan Tool, clear all DTCs.
Correction # 2
1.
The Evaporative Emissions Vent Solenoid is retained by a molded in, plastic extension. The retainer has molded in ridges that create an
interference fit to the underbody. Under some instances, the retainer may have not been fully seated when installed.
2.
Remove the jumper harness from the Evaporative Emissions Vent Solenoid.
Important:
^
The fastener style used to retain the Evap Vent Solenoid does not provide feedback to the technician in the form of a "click" or detente
when properly installed. You should seat the fastener as deeply as possible without using excessive or damaging force.
^
The vent solenoid will not be retained rigidly even when properly installed.
3.
Inspect the retainer for damage. Additionally, examine the solenoid body for any signs of damage. If the retainer and solenoid body appear in good
condition, reinstall to the underbody cut out. Verify that the fastener holds properly by pulling on the solenoid body to check that it is retained. If
the fastener will not retain properly or there are signs of damage, replace the Evap Vent Solenoid.
4.
Discard and replace the jumper harness with P/N 12101858.
5.
Lower the vehicle.
6.
Using the Tech 2(R) Diagnostic Scan Tool, clear all DTCs.
Parts Information
Parts are currently available at GMSPO.
Warranty Information
