Cavalier L4-2.2L VIN F (2004)
9.
Place another insulator in the next location by repeating Steps 5 through 8. There should be 10 insulators placed on each wheel cover.
Correction (2003 and 2004 Model Years)
Install insulator tape on the backside of all four wheel covers. Use the following procedure listed below.
1.
Remove the wheel covers.
2.
Clean the backside of each wheel cover using a mild liquid detergent in a distilled or deionized water solution. Rinse each wheel cover with clean
water.
3.
Dry each wheel cover using compressed air or a clean, lint-free, non-abrasive cloth.
4.
After the wheel covers are completely dry, each wheel cover should be wiped with isopropyl alcohol on a clean, lint-free, non-abrasive cloth at the
insulator locations. Refer to the illustrations above.
5.
Cut (40-Cavalier or 36-Sunfire) 7 mm (.275 in) lengths of *3M(R) Squeak Reduction Tape 5430, P/N 06356.
6.
Peel the non-stick backing off tape.
7.
Carefully place the tape (insulator) onto the wheel cover's backside, outer most edge, as shown.
8.
Press down firmly on the insulator to ensure that the adhesive is bonding to the wheel cover.
9.
Repeat steps 6 through 8 with the remaining insulators. There should be (10-Cavalier or 9-Sunfire) insulators placed on each wheel cover.
Important:
