Cavalier L4-2.2L VIN F (2004)
Wheel Fastener: Service and Repair
Front Suspension
WHEEL STUD REPLACEMENT
TOOLS REQUIRED
J 43631 Ball Joint Separator
REMOVAL PROCEDURE
1. Raise the vehicle on a hoist. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the hub and bearing assembly.
4. Remove the wheel stud (1) from the hub and bearing assembly (2) using the J 43631.
5. Discard the stud.
INSTALLATION PROCEDURE
1. Install the replacement stud into the hub and bearing assembly (2).
2. Add enough washers in order to draw the stud into the hub (2).
3. Install the wheel nut (1) with the flat side against the washers (3).
4. Tighten the wheel nut (1) until the wheel stud is fully seated against the hub flange.
5. Back off the wheel nut (1) and remove the washers (3).
6. Install the hub and bearing assembly.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
