Cavalier L4-2.2L VIN F (2004)
3. Remove the torque convertor O-ring seal from the end of the turbine shaft. Use a screwdriver.
Installation Procedure
1. Install a new torque convertor O-ring seal on the end of the turbine shaft.
2. Install the torque convertor onto the transmission.
3. Install the transaxle into the vehicle.
Case Side Cover Seal Replacement
Case Side Cover Seal Replacement
^
Tools Required
-
J 41227 Output Shaft Sleeve Remover
-
J 41228 Stub Shaft Sleeve Installer
-
J 41102 Axle Seal Installer
Removal Procedure
Caution: Refer to Vehicle Lifting.
1. Raise the vehicle.
2. Remove the drive axle assembly.
