Cavalier L4-2.2L VIN F (2004)
Wheel Bearing: Testing and Inspection
WHEEL BEARINGS DIAGNOSIS
TOOLS REQUIRED
J 8001 Dial Indicator
The following procedure describes how to inspect the wheel bearing/hub for excessive looseness. If you are inspecting the wheel bearing/hub for
excessive runout, refer to Hub/Axle Flange and Wheel Stud Runout Inspection in Vibration Diagnosis and Correction.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Mount and secure the J 8001 to a stand.
IMPORTANT:If you are inspecting the FRONT wheel bearing/hub, support the front of the vehicle by the lower control arms in order to load the lower
ball joint.
3. Ensure that the J 8001 contacts the vertical surface of the wheel as close as possible to the top wheel stud.
4. Push and pull on the TOP of the tire.
5. Inspect the total movement indicated by the J 8001.
6. If the measurement exceeds 0.127 mm (0.005 in), replace the wheel bearing/hub.
