Cavalier/Z24 L4-134 2.2L (1991)
1.
Remove center rail weatherstrip retaining screw. Refer to Figure 8.
2.
Remove front rail weatherstrip retaining screw. Refer to Figure 8.
3.
Remove approximately 100 mm (4.0 inch) of weatherstrip from rear to center of front retainer.
4.
Remove approximately 100 mm (4.0 inch) of weatherstrip from front to center of center retainer.
5.
Using black weatherstrip adhesive, P/N 12345097, or equivalent, install front and center rail weatherstrips into retainer, pulling ends together
until contacting. Refer to Figure 8.
6.
Install front and center rail weatherstrip retaining screws. Refer to Figure 8.
4A.
To correct front rail weatherstrip to center rail weatherstrip puckering, use the following procedure.
1.
Lower convertible top about halfway.
2.
Remove center rail weatherstrip retaining screw. Refer to Figure 8.
3.
Remove front rail weatherstrip retaining screw. Refer to Figure 8.
4.
Remove approximately 100 mm (4.0 inch) of weatherstrip from rear to center of front retainer.
5.
Remove approximately 100 mm (4.0 inch) of weatherstrip from front to center of center retainer.
6.
Install stuffers (two each end) into the cut-away in back of weatherstrips. Refer to Figure 7. This will push the weatherstrip surface back to its
original shape.
7.
Raise convertible top and lock.
8.
Using black weatherstrip adhesive, PIN 12345097, or equivalent, install front and center rail weatherstrips into retainer, pulling ends together
until contacting. Refer to Figure 8.
9.
Install front and center rail weatherstrip retaining screws. Refer to Figure 8.
5.
To correct center rail weatherstrip to rear rail weatherstrip gaping, use the following procedure:
1.
Lower convertible top about halfway.
2.
Lower quarter window.
3.
Remove center rail weatherstrip retaining screw.
4.
Remove approximately 1OO mm (4.0 inch) of weatherstrip from front to center of retainer.
