Cavalier/Z24 L4-134 2.2L (1991)
Dome Lamp: Customer Interest
Lights - Dome & Reading Lamp Assembly Loose
Number: 92-331-8B
Section: 8B
Date: NOV. 1992
Corporate Bulletin No.: 231067
ASE No.: A6
Subject:
DOME AND READING LAMP ASSEMBLY LOOSE
Model and Year:
1990-92 CAVALIER
CONDITION
Some owners of 1990-1992 Chevrolet "J" series vehicles with plastic dome and reading lamp assemblies may comment that the lamp assembly comes
loose or falls from its attachment holes in the roof bow.
CAUSE
Base of lamp assembly bends slightly under high heat conditions or from excessive motion. Outside edge of each integral fastener then pulls away from
metal of roof bow, resulting in poor retention of lamp assembly to roof bow.
CORRECTION
Replace current plastic dome and reading lamp assembly, GM P/N 22546379 with GM P/N 22585970 using the following procedure:
Remove or Disconnect
1.
Grasp front and rear of lamp assembly and pull downward while rocking lamp assembly back and forth to disengage integral fasteners from holes
in roof bow.
2.
Electrical connectors.
Install or Connect
1.
Electrical connector to new lamp assembly (GM P/N 22585970).
2.
Position integral fasteners of lamp assembly to holes in roof bow and press lamp assembly into place. Inside edge of integral fastener contacts
metal of roof bow to retain new lamp assembly.
Parts are currently available from GMSPO.
Labor Operation Number: N1456
Use applicable labor time guide for labor hours.
