Cavalier/Z24 L4-134 2.2L (1991)
Correction:
Refer to Illustrations for location of repairs.
Repair Procedure:
-
Remove secondary ignition wire bracket and wires, set aside.
-
Remove clutch cable retainer and cables, set aside. (Manual transaxle only.)
-
Un-clip engine wiring harness conduit from retainer, pull back conduit to expose harness.
-
Using common "black" electrical tape (locally attained part), begin taping approximately 5 inches back from the point where the main harness breaks
out into 3 smaller harnesses.
-
While taping to the break-out point, push the individual smaller conduits back and tape up the harnesses as far as possible.
*
IMPORTANT: Tape wire harness with 4 layers of tape to insure proper insulation.