Cavalier/Z24 L4-134 2.2L (1991)
14.
Repeat steps 12 and 13 until all traces of the burr have been removed from the bottom and left sides of the slider opening.
15.
From the back side of the slider opening, use oompressed air to clean the slider opening in the lock cylinder housing assembly. Make sure that no
filings remain to obstruct slider or locking pin movement.
16.
Install the park lock cable. Make sure the cable locking tab is firmly seated and latched in the lock cylinder housing slot.
17.
Test for proper operation of the park lock system by repeating the check procedure in the "Description" section.
18.
Reassemble column in reverse order. Note: Refer to the vehicle service manual for detailed reassembly instructions.
WARRANTY INFORMATION:
Labor Operation Number:
T1714 (Adjust and remove burrs)
Labor Time:
0.6 hour
Labor Operation Number:
K5173 (Park lock cable adjust)
Use applicable labor time guide for labor hours.
Trouble Code:
92
