Cavalier/Z24 L4-134 2.2L (1991)
*
IMPORTANT: If any wires are worn through enough to short out against each other, if strands of wire are broken, or if an "open" wiring condition
is found, refer to Section 8A of the applicable Service Manual for proper wiring repair.
-
Install wiring harness back into conduit. Before clipping retainer closed, pull the harness towards the center of the vehicle to remove any slack in the
harness. This will keep the harness off the transaxle case and away from the transaxle controls.
-
Clip harness retainer into position.
-
Reinstall clutch cables and retainer. (Manual transaxle only).
-
Reinstall secondary ignition cables and bracket.
Warranty and Labor Time Information:
For taping and repositioning harness:
Labor Code:
T1789
Labor Time:
0.3 Hours
For wiring repair, taping and repositioning of harness:
Labor Code:
T1789
Labor Time 0.4 Hours
