Cavalier/Z24 L4-138 2.3L DOHC VIN D MFI (1995)
REMOVE OR DISCONNECT
1. Left sound insulator.
2. Release cable retainer from lever assembly.
3. Depress cable tangs and push forward toward engine compartment.
4. Engine accelerator control cable out of bracket.
5. Depress tangs on cable through cable bracket.
6. Cable.
INSTALL OR CONNECT
1. Route cable through cable bracket.
2. Press cable upward through bracket making sure tangs expand and properly seat.
3. Engine accelerator control cable to cam.
4. Cable to cowl, making sure tangs fully expand and seat.
5. Slip accelerator cable through slot in rod and then install retainer in rod, being sure it is seated.
Inspect
Check for correct opening and closing positions by operating accelerator pedal. Make sure that the throttle valve reaches wide-open throttle
position. If it does not, inspect for damaged or bent brackets, levers, or other components; or, for poor carpet fit under the accelerator pedal.
Flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2.0 in.) of moving parts of accelerator linkage outboard of
support unless routing is positively controlled.
6. Left sound insulator.
