Cavalier/Z24 L4-138 2.3L DOHC VIN D MFI (1995)
To repair this condition a revised forward clutch housing assembly complete, (including fiber and steel plates) must be installed with a revised assembly.
The revision to this assembly is a new piston assembly (607) and inner seal and sleeve assembly (608). The new piston assembly has additional rubber
material molded to it. The inner seal and sleeve assembly has a molded plastic insert. These revisions help reduce the volume of oil required to allow the
forward clutch assembly to apply. The forward clutch housing assembly must be replaced as a complete assembly. (See Figure 3)
Service Information
Road test the vehicle following an overnight cold soak as described under "Condition." Verify the vehicle has a delay during the initial shift into drive.
Replace the complete forward clutch housing assembly with the one supplied in service kit (P/N 24210576). Refer to the Unit Repair Section of the
Service Manual for the proper procedure.
A new service kit (gasket kit-trans with seals P/N 24210577) has been released which may be useful in obtaining the additional gaskets and seals that
may be needed in the servicing of a lower mileage vehicle. For transaxles which require a complete reconditioning, the overhaul complete service kit
should be ordered. Refer to parts catalog for the complete overhaul part number.
Parts Information
Part Number
Description
24210576
Forward Clutch Housing
Complete
24210577
Gasket Kit-Trans with Seals
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use:
