Cavalier/Z24 L4-144 2.4L DOHC VIN T SFI (1996)
Accelerator Pedal: Service and Repair
REMOVE OR DISCONNECT
1. Left sound insulator.
2. Release cable retainer from lever assembly.
3. Nuts to cowl.
4. Pedal assembly.
INSTALL OR CONNECT
1. Pedal assembly to cowl.
2. Nuts to cowl.
Tighten
Nuts to 30 Nm (25 lb. ft.).
3. Slip accelerator cable through slot in rod and then install retainer in rod, being sure it is seated.
4. Left sound insulator.
Inspect
-
Check for correct opening and closing positions by operating accelerator pedal. Make sure that the throttle valve reaches wide~open throttle
position. If it does not, inspect for damaged or bent brackets, levers, or other components; or, for poor carpet in under the accelerator pedal.
-
Flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2.0 in.) of moving parts of accelerator linkage outboard of
support unless routing is positively controlled.
