chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

All Technical Service Bulletins for Steering Rack Gear:|533202A > < Steering - Knocking Noise Heard at Low Speeds|Page 8308
Page 3
background image

A knocking noise heard while turning and driving over a bump at the same time involves 1996 vehicles with 2.2L engines (VIN 4 - RPO LN2) built prior
to the listed VIN breakpoints as shown. This condition may be corrected by installing a power steering restrictor valve, P/N 22592200, into the pump
reservoir inlet. Restrictor can only be installed on vehicles equipped with power steering cooler pipes.

Use the following installation procedure

1.

Inspect vehicle to insure vehicle is equipped with a power steering cooler pipe.

2.

Install restrictor in the inlet tube of the power steering fluid reservoir.

3.

Restrictor should be pushed in by hand until snug, not forced or hammered.

4.

Return hose should be pushed over the restrictor and inlet tube, then clamped.

Parts Information

Parts are currently available from GMSPO.

Warranty Information

For vehicles repaired under warranty, use as shown.

All Technical Service Bulletins for Steering Rack Gear:|533202A > < Steering - Knocking Noise Heard at Low Speeds|Page 8308