Cavalier/Z24 L4-144 2.4L DOHC VIN T SFI (1996)
Window Seal: Technical Service Bulletins
Header Weatherstrip - Revised Replacement Procedure
File In Section: 10 - Body
Bulletin No.: 83-15-03
Date: August, 1998
SERVICE MANUAL UPDATE
Subject:
Section 10-13 - Revised Remove and Install Procedure for Header Weatherstrip and Retainers
Models:
1995-98 Chevrolet Cavalier (Convertible Only)
1995-98 Pontiac Sunfire (Convertible Only)
This bulletin is being issued to revise the remove and install procedure for header weatherstrip and retainers, convertible only, in Section 10-13 of the
Service Manual.
Procedure
Header Weatherstrip and Retainers
Remove or Disconnect
Important:
Removing the weatherstrip retainers is not necessary if only the weatherstrip is to be serviced.
1.
Unlatch and lower folding top.
2.
Windshield garnish molding. Refer to Windshield Garnish Molding in this section.
3.
Push-pin retainers securing the header weatherstrip at top of the LH and RH A-pillars.
4.
Clips securing the header weatherstrip at bottom of the LH and RH A-pillars.
5.
Header weatherstrip by pulling up while separating the adhesive bond with a flat bladed tool.
6.
Screws securing A-pillar weatherstrip retainer.
7.
Screws securing header weatherstrip retainer.
8.
Header weatherstrip retainer.
9.
Header garnish molding retainer.
Clean
^
Adhesive from parts that will be reused
^
Foam tape from parts that will be reused
^
Foam tape from header surface
^
Butyl tape from header surface
Inspect
^
Header weatherstrip for holes, rips or breaks in the surface skin. If holes, rips or breaks are found, the weatherstrip must be replaced.
Install or Connect
