Celebrity V6-173 2.8L (1989)
Rear Knuckle: Service and Repair
1.
Remove hub and bearing assembly as outlined under TRANSMISSIONS CLUTCHES DIFFERENTIALS AXLES AND DRIVE
AXLES/AXLE, DRIVE SHAFTS/COMPONENT REPLACEMENT AND REPAIR/REAR AXLE/HUB & BEARINGS.
2.
Remove speed sensor and bracket from knuckle, then outer toe link castle nut.
3.
Install spring compressor No. J-33432 on leaf spring to support control arm.
4.
Scribe position of strut to knuckle bolts, then remove strut to knuckle bolts.
5.
Remove outer control arm bolt/nut, then knuckle from vehicle.
6.
Reverse procedure to install, torquing bolts/nuts to specifications.