Celebrity V6-173 2.8L (1989)
Figure 2 - Side Cover to Channel Plate Gasket And Wiring Harness
SUBJECT:
NEW WIRING HARNESS TO PREVENT PINCHED/SHORTED CONVERTER CLUTCH SOLENOID WIRES
This section covers a revised wire routing for the Torque Converter Clutch Solenoid (TCC) and requires a new Wiring Harness. The TCC wires are now
routed straight down from the Engine Wire Harness Connector to the TCC Solenoid instead of going around the Oil Pump Body. This reduces the
possibility of the TCC wires becoming pinched/ shorted between the Pump Cover and the Case Side Cover Pan during assembly. For this change to
occur, a Wire Conduit Clip (TCC) Figure 2, has been added to secure the Wire Conduit (TCC).
SERVICE ACTION:
The new Wire Harness wll not be available for service. When using the old style wire harness ensure the routing will not allow the wires to get pinches
between the pump cover and case side cover pan during assembly. This new TCC solenoid wire conduit clip must be used.
