Celebrity V6-260 4.3L DSL (1982)
FIGURE 2
engine to run until it reaches operating temperature. Set idle speed to specification then turn engine off.
3.
Remove air crossover assembly. Install screen covers J-29657.
4.
With transmission in park and A/C off, start engine.
5.
Loosen locknut (Figure 2) and slowly turn metering valve stop screw clockwise until idle speed drops approximately 10 rpm.
6.
Turn metering valve stop screw counterclockwise three
(3)
turns. Tighten locknut.
7.
Check for fuel leaks around metering valve stop screw.
8.
Turn engine off.
9.
Remove magnetic tachometer probe and screened covers from intake manifold and reinstall parts removed.
FIGURE 3
10.
Fill in dealer code and date on the supplemental emission control label, P/N 14057201 or equivalent (Figure 3). This label must be placed next to
the existing underhood emission control information label. Wash off the area with soap and water, dry thoroughly, and apply the new label.
PARTS INFORMATION
Part
P/N
