Citation V6-173 2.8L VIN Z 2-bbl HP (1983)
4.
MILEAGE: Enter mileage at time of transaction. (If not available, enter "0". 5. FC Code is preprinted on form.
6.
LABOR OPERATION NO. - Use T1303.
7.
& 8. SUBLET DMN & LINE TOTAL: Enter total amount of reimbursement. (Do not enter parts or labor hours on claim.)
9.
AUTH CODE: If the amount of reimbursement approved is $500 or less, no authorization is needed. If the amount exceeds $500, contact
Chevrolet Branch Customer Assistance Representative for instructions.
10.
REQUESTED REIMBURSEMENT: Dealer Service Manager enter amounts determined from owner supplied invoices or paid receipts, which are
covered.
11.
APPROVED AMOUNT & 740 STAMP: Dealer Service Manager to determine based on reimbursement policy of this bulletin. If the total amount
exceeds $500, contact Chevrolet Branch Customer Assistance Representative for instructions.
12.
See Item 11 to determine need for authorization.
13.
DEALER REFERENCE INFORMATION:
A.
Enter Document Number and Line Number on which claim was submitted.
B.
Enter Claim Memo Number and Date when claim is credited.
C.
Enter Number of Dealer Check to Owner, if applicable. Date Check was written, if applicable. Date copy of Check was attached to
OWNER REQUEST FOR REIMBURSEMENT file.
14.
OWNER INFORMATION (must include telephone number).
15.
DEALER INFORMATION & SERVICE MANAGER SIGNATURE: To be completed by Service Manager.
16.
EXPLAIN: Should the Dealer Service Manager determine, after review of owner's invoices/receipts, that the reimbursement case is not eligible;
Service Manager should write reason on worksheet, explain to owner, and place a copy of the worksheet in the file.
If the amount approved by the Chevrolet Representative is different from the amount determined by the dealer, the Chevrolet Representative
will provide a reason as an explanation to the owner.
17.
The Dealer is then to issue the owner a check for reimbursement in the approved amount. A copy of the check issued to the owner is to be attached
to the Dealer's file copy of the request within 30 days after Dealer credit is received and retained for 24 months from date of credit.
Instruction Sheet For Effective Repair, Use All Parts In Kit Regardless of Original Condition.
SERVICE PROCEDURE FOR INSTALLING
"SPECIAL" VALVE BODY RINGS ON RACK
AND PINION ASSEMBLIES WITH HARD STEERING
ON INITIAL START-UP
READ INSTRUCTIONS COMPLETELY AND CAREFULLY BEFORE PROCEEDING.
Some complaints about the power steering system on initial start up may be reported as:
^
Reduced power steering assist when parking.
^
Increased steering effort.
For further information, refer to the "Steering Diagnosis" section in vehicle service manual.
Tools Required:
J 37090 Pinion and Valve Ring Protector J 29822 Pinion Seal Installer J 29810 Stub Shaft Seal Protector
A.
Remove rack and pinion assembly from car.
