Citation V6-173 2.8L VIN Z 2-bbl HP (1983)
3.
If reading is greater than 5 amps, disconnect wiper linkage at crank arm and perform test over. If reading is now less than 5 amps, check for
binding linkage and replace wiper blades.
4.
If lowest reading still exceeds 5 amps, repair or replace motor.
Fig. 10 Permanent magnet non-depressed park type windshield wiper motor. Exc. Citation, Omega, Phoenix & 1982---85 Skylark (Note: The harness connector may be labeled D-C-B-A instead of 1-2-3-4)
Motor Inoperative At Low Or High Speed
1.
Disconnect electrical connector to wiper motor.
2.
If motor operates at high speed, connect battery voltage to low speed terminal 2, Fig. 10. If motor operates at low speed, connect battery voltage to
high speed terminal 1, Fig. 10.
3.
If motor operates at affected speed, check continuity of wiring between motor and switch. If wiring is satisfactory, switch is defective.
4.
If motor fails to operate in affected speed, repair or replace motor.
Motor Operates At One Speed In Both High & Low Switch Positions
1.
Disconnect electrical connector to wiper motor and alternately connect battery voltage to motor low and high speed terminals, Fig. 10.
2.
If motor runs at both low and high speeds, check continuity of wiring between motor and wiper switch. If wiring is satisfactory, wiper switch is
defective.
